Silent Hill: Townfall PC System Requirements (2026) – Minimum and Recommended Specs

Konami has confirmed the official Silent Hill: Townfall PC system requirements ahead of the game’s September 24, 2026, launch. This survival horror title from Scottish studio Screen Burn demands noticeably more hardware than last year’s Silent Hill f, especially on the RAM and GPU side.

Silent Hill: Townfall requires Windows 11 64-bit and 75 GB of storage at every setting tier. The minimum specs target 1080p at Low settings and 30 FPS, while the recommended specs aim for 4K at High settings, also at 30 FPS, using upscaling.

Silent Hill: Townfall PC System Requirements

Here’s the full breakdown of what Konami says you’ll need to run the game, straight from the official specifications.

Source: Official Silent Hill: Townfall Steam page specifications, published by Konami.

Recommended Specs for Optimal Performance

The recommended tier is built around 4K resolution rather than raw frame rate, and it still tops out at 30 FPS even at the high end. That’s an unusual choice, and it means players chasing 60 FPS will want to budget for hardware well beyond what Konami lists here.

The jump to 32 GB of recommended RAM is the biggest change from Silent Hill f, which only asked for 16 GB even at its highest tier. Combined with the RTX 3080 recommendation, Townfall is shaping up to be one of the more demanding entries in the series on PC.

Can My PC Run Silent Hill: Townfall?

Checking your specs takes a couple of minutes on either platform. Here’s how to find what you’re working with.

1. On Windows, press the Windows key, type “System Information,” and open the app. Your processor and installed RAM are listed under System Summary.
2. Check your graphics card by opening Task Manager, clicking the Performance tab, and selecting GPU.
3. On Mac, click the Apple menu, select About This Mac, and review the chip and memory listed there. Note that Silent Hill: Townfall’s confirmed requirements are Windows-only at this time.
4. Compare what you find against the minimum and recommended columns above to see which tier your PC falls into.

Performance Tips and Settings Recommendations

DLSS, FSR, and TSR upscaling are all supported, and turning one on is the easiest way to close the gap between your hardware and the recommended tier. Balanced mode is what Konami used to reach the stated 4K performance target, so it’s a reasonable starting point before you tune further.

Players on 16 GB of system RAM should expect to run into texture streaming hitches at higher settings, since Townfall leans on RAM more heavily than most recent Unreal Engine 5 titles. Dropping to Medium textures first, rather than lowering resolution, tends to free up the most headroom without hurting the game’s atmosphere.

If you’re sitting right at the minimum GPU tier, an RTX 2060 Super or RX 6600, stick to 1080p and Low settings rather than pushing 1440p. The minimum spec was built around that exact combination, and going higher will likely introduce frame drops during heavier environmental sequences.

Frequently Asked Questions